I recently purchased KS3.1 roms to upgrade my A3000 that came with KS2.04. For the KS2.04 ROMS, ROM0 is in U181 and ROM1 is in U180 (marking of ROM0 and ROM1 on the motheboard is wrong.. or markings on the ROMs are wrong.. many hours wasted trying to figure out why my computer wasn't booting).
When I install the new 3.1 roms, I get black screen. One was marked U180 and the other U181. I tried switching them but I got the same result. With them back in their respective spots, I tried setting the ROM speed to 16 MHz (J151 and J152) and still got black screen. Pin 1 is facing the daughterboard and there are no bent/unseated pins.
The motherboard is v8.9 with no ROM tower.
Any suggestions? The vendor said they were tested in an A3000 before they were shipped and offered to send me another set if needed.
When I install the new 3.1 roms, I get black screen. One was marked U180 and the other U181. I tried switching them but I got the same result. With them back in their respective spots, I tried setting the ROM speed to 16 MHz (J151 and J152) and still got black screen. Pin 1 is facing the daughterboard and there are no bent/unseated pins.
The motherboard is v8.9 with no ROM tower.
Any suggestions? The vendor said they were tested in an A3000 before they were shipped and offered to send me another set if needed.