Hi All I bought an Individual MK2cr for my A1200 and I am disappointed in it's
performance. I was using it on an BENQ 937 21 inch monitor. First it can not switch
on the go from NTSC to Pal. If your amiga display can not due that then why use it?
Second it does not display certain programs or views unless I load the WB with original
Chipset, weird. Or if I try looking at images from a program like VT after a few displays it
stops being able to display the images. Just says signal not detected. I switched monitors
to my Commodore 1950 and got basically the same results. So I am open to suggests, advice, help. I am contacting my reseller as instructed but would like to hear from anyone else
who might understand my issues.
Thank you
Brad Hansen
performance. I was using it on an BENQ 937 21 inch monitor. First it can not switch
on the go from NTSC to Pal. If your amiga display can not due that then why use it?
Second it does not display certain programs or views unless I load the WB with original
Chipset, weird. Or if I try looking at images from a program like VT after a few displays it
stops being able to display the images. Just says signal not detected. I switched monitors
to my Commodore 1950 and got basically the same results. So I am open to suggests, advice, help. I am contacting my reseller as instructed but would like to hear from anyone else
who might understand my issues.
Thank you
Brad Hansen
