I'm trying to setup a Seagate ST31055N in a GVP A530 but am unable to get Fastprep to see the drive. The A530 is plugged in to an A500(+?) with Kickstart v37.175 (2.04) and the drive that came with it works without issue (a Quantum Prodrive ELS 170S).
I've tested both drives in WinXP using an Adaptec AHA-2940W without issue or any change in configuration, i.e. no change in termination, both SCSI ID 0.
With the Quantum, I can boot from the GVP.Install floppy disk and Fastprep can see the drive. With the Seagate installed, the system won't load WB from any disk unless I disable Autoboot on the A530 (jumper J9 open).
Is the Seagate just not compatible or am I missing something?
I've tested both drives in WinXP using an Adaptec AHA-2940W without issue or any change in configuration, i.e. no change in termination, both SCSI ID 0.
With the Quantum, I can boot from the GVP.Install floppy disk and Fastprep can see the drive. With the Seagate installed, the system won't load WB from any disk unless I disable Autoboot on the A530 (jumper J9 open).
Is the Seagate just not compatible or am I missing something?