I recently received an ACARD (IDE to SCSI Interface) and installed a new 60GB SSD drive on it. It works find, is detected and I can partition it. I set it as 2X 2.0GB and the other two are spit with the remaining. All good there. I set the first two intended to be my system and backup as SFS, and the other two non bootable as Work1 and Work2 as PFS.
When I save and reboot it wont let my system boot any longer. So I took it out, wiped it out again, and started over. Same problem. One more try and I left them as FFS. No problem this time.
Question is, am I missing something trying to set 2 partitions as SPS and the other two as PFS?
I have a 17GB SCSI in now set up this way and want to duplicate it so I can replace it with this new SSD.
When I save and reboot it wont let my system boot any longer. So I took it out, wiped it out again, and started over. Same problem. One more try and I left them as FFS. No problem this time.
Question is, am I missing something trying to set 2 partitions as SPS and the other two as PFS?
I have a 17GB SCSI in now set up this way and want to duplicate it so I can replace it with this new SSD.
